All active GPS antennas include a built-in Low Noise Amplifier (LNA) which provides sufficient gain to overcome coax cable losses while providing the proper signal level to the GPS receiver.
See Synergy Systems, LLC Tech-Note TN-488 for Antenna to GPS receiver connection recommendations. This Tech-Note explains several ways to connect GPS antennas to the GPS receivers. Coax extension cables and coax cables for permanent mount antennas are also discussed.
|
|
GPS Active
|
|
The ruggedized, dual-filtered SSA-5 GPS antenna is designed for "through-hole" mounting on heavy equipment, locomotives, rail cars and military vehicles. Its 7/8 inch diameter threaded mounting stem allows the SSA-5 to be designed into new applications and also to replace older VIC-5 "Fleet Management Antennas" in the field. Mounting brackets and pipe adaptors quoted on request.
data sheet |
|
|
GPS Active
|
|
Features:
- Magnetic mount
- 2.75 to 12.0Vdc voltage range
- 28dB gain
- Filtering: BPF<10MHz @ -3dB point
- RF protection (10Watts), nano-second spark-gap
- Low profile
- 5m cable
- Many connector options
data sheet
|
|
|
GPS Active
|
|
Features:
- Magnetic mount
- 3Vdc to 5Vdc voltage range
- 25dB gain
- Low profile
- Direct mount plate option
- 5m cable
- Many connector options
data sheet |
|
|
GPS Active
|
|
Features:
- Magnetic mount
- 3Vdc to 5Vdc voltage range
- Low power, 6mA @ 3V
- 28dB gain
- Small Size
- 3m cable
- Many connector options
(data sheet) |
|
|
GPS Active
|
|
Features:
- Through hole direct mount
- 2.5Vdc to 5.5Vdc voltage range
- 30dB gain
- Low Profile
- Gasket seal
- Extra lock nut
- Bulkhead or 5m cable
- Many connector options
data sheet |
|
|
GPS Active
|
|
The Timing 1000 is a GPS antenna optimized for fixed location timing applications.
Key features include:
- Compact polycarbonate radome with
water/weatherproof physical construction
- Directly replaces the discontinued Panasonic
Marine II antenna
- 1"-14 marine mount allows cable to be routed
through the support pipe protecting it from
enviromental damage.
- Dual filtered, high gain of 30dB and low current
of 27mA.
- Bulkhead TNC connector
data sheet
|
|
|
GPS Active
|
|
The End of Life(EOL) has been announced for the Timing3000 GPS Antenna. For details, please review the End of Life announcement below or contact a Synergy Systems, LLC Representative. EOL Announcement The Timing 3000 is a 100% form, fit, function replacement for the original Motorola Timing2000 GPS Antenna.
Features: - Through hole direct mount
- 4.75Vdc to 5.25Vdc voltage range
- 25dB gain
- Designed for precison timing applications
- Mounts with optional right angle bracket or pipe adapter
- Dual pole filter
- Rugged N style coaxial connector
data sheet |
|
|
GPS Active
|
|
The VIC-100 GPS antenna is the telecom industry standard. It's triple-filter LNA provides excellent signal reception in high RF interference environments.
One version of the VIC-100 offers protection against lightning induced damage with circuitry that performs per IEC61000-4-5 standard. |
|
Read more...
|
|
|
GPS Active
|
|
Replacement for AN-05E gps antenna. Features:
- Direct mount to PC board
- 3.0Vdc to 6.0Vdc voltage range
- 27dB gain (less cable)
- Many connector options
(data sheet) |
|
|
GPS Active
|
|
Features:
- Designed for embedded applications
- 3.0Vdc to 5.0Vdc voltage range
- 25dB gain
- Ground plane option
- Many connector options
data sheet
|
|
|
Quad-band Combo GPS/GSM Antenna |
|
|
|
|
GPS Active
|
|
 Features: - Magnetic Mount or Thru Hole Mount
- Operating GSM Frecuencies: 850/900/1800/1900 MHz
- Output VSWR: </= 1.5 dB
- Output Impedance: 50 Ohm
- Op Temp Range: -40º C to +85º C
- Storage Temp: -45º C to +100º C
- Humidity:95% RH,non-condensing
- GPS Frequency: 1575.42 MHz
 - Gain: 26 -27 dB typical (refer to data sheet for details)
- Power Comsumption: 2.7-5.5Vdc, 13mA
data sheet |
|
|
<< Start < Prev 1 2 Next > End >>
|
| Results 1 - 11 of 12 |